Modified Scheme for LED Packaging Adhesive: IOTA ESM Multi-branch Polyether Modified Epoxy Silicone Oil, Improving Internal Stress and Wettability of the Adhesive Layer

Hits: 730 img

Modified Scheme for LED Packaging Adhesive: IOTA ESM Multi-branch Polyether Modified Epoxy Silicone Oil, Improving Internal Stress and Wettability of the Adhesive Layer


1. Epoxy activity + Polyether Branch Chains, achieving chemical bonding modification
IOTA ESM multi-branch polyether modified epoxy silicone oil, with side chains distributed along multiple polyether chains and epoxy active sites, can participate in the curing and cross-linking of the epoxy packaging adhesive. It is not a simple blending addition. The polyether chains enhance the wettability of the adhesive layer to the chip and substrate base, and the multi-branch structure disperses the curing stress, alleviating the phenomenon of internal stress concentration after the adhesive layer hardens.


2. For the LED packaging scenario, it can reduce the risk of defective products
Used for the modification of epoxy LED packaging adhesives and lens adhesives, it can improve the toughness of the adhesive layer, improve cracking and detachment defects under low-temperature and high-temperature shock; optimize the flowability of the adhesive liquid, reduce bubbles and pinholes during the packaging process, and moderately adjust the refractive index and light transmission performance of the adhesive material, suitable for the development of small and medium-power LED light source packaging formulations.


3. Customer Frequent Questions and Answers
Q: After adding this silicone oil, will it affect the light transmittance of the packaging adhesive?
A: Within a reasonable addition range, the impact on light transmittance is small. Excessive addition is likely to cause phase separation and an increase in haze. It is necessary to test the light transmittance indicators through gradient sampling.

Q: Compared with ordinary linear epoxy silicone oil, where does the advantage of cold and hot shock resistance lie?
A: The multi-branch network structure has better stress relief ability after curing, and the interface between the adhesive layer and the substrate is less likely to delaminate during repeated high and low temperature cycles.


4. Product Selection and Process Recommendations
If developing an epoxy-based LED packaging adhesive, the key issues to address are cracking under hot and cold shock and the difference in substrate wettability. IOTA ESM is worthy of priority testing. It is recommended to be invested in the resin pre-mixing stage, fully stirred and dispersed; the curing system and addition ratio need to be matched and verified in combination with the curing agent system.

Recommend

    Online QQ Service, Click here

    QQ Service

    What's App